Stainless Steel Kitchen Cabinets Suppliers Introduces Moisture-proof Measures For Kitchens

The fumes and humidity in the kitchen often bother many friends. More importantly, the germs brought by long-term humidity can have a serious impact on the health of family members. Then, Stainless Steel Kitchen Cabinets Suppliers will introduce how to do a good job in the moisture-proof work of the kitchen?

1. Pay attention to practicability when selecting materials
The floor material is the key part of moisture-proof. It is recommended to choose floor tiles with anti-slip function and not easy to be stained with oil, which is economical and practical. In addition, some new composite floors have a special non-slip protective layer added to the surface, which is very resistant to moisture, non-slip, and scratches. The wall material should choose easy-to-clean ceramic tiles. If the wall is painted, it is best to choose moisture-proof wall paint. At the same time, the moisture content of the wall should be about 10%. Also, pay attention to daily cleaning, otherwise, the wall will get wet. bubble.

The ceiling will inevitably be corroded by water vapor. It is recommended to use plastic gussets with better waterproof performance and carry out waterproof membrane treatment during decoration. In addition, if the kitchen is relatively low, it can also be painted directly with waterproof paint to prevent moisture.

2. Kitchen furniture dry and wet separation
If the sink location is improper or the design is not considered properly, it is easy to cause deformation of the cabinet or mildew of the material. It is recommended to lay the floor first, and then make the cabinets during the decoration. This will not only be accurate in size but also ensure that the cabinets have been dried enough during installation to avoid excessive heat expansion and contraction of moisture intrusion that may cause the cabinets to become mildew.

When choosing a sink, don't just consider the material and size, because the water dripping down the pipe will easily make the bottom of the sink cabinet damp, so you must pay attention to whether the rubber strip of the sink is tightly sealed. It is recommended to install an aluminum bottom plate with anti-collision strips on the bottom of the sink cabinet, which can not only eliminate the door closing noise but also prevent the cold water dripping from the basin and faucet from soaking the cabinet and prolong the service life of the pool.

3. Dehumidify the dead corner of the hygiene
Sewers, ceiling interiors, and corners are often dead corners in the kitchen, which can easily collect moisture or trap dirt. If the joint of the kitchen drain pipe is not tightly sealed, it is easy to seep water and give off a bad smell. Since the sewer interface is in a relatively hidden place, it is recommended to seal the gap at the interface with glass glue or other adhesives. In addition, installing a hole cover at the opening of the sink cabinet can also prevent moisture.

The ceiling of the kitchen is easy to accumulate oil droplets and watermarks and deformities. If the ceiling lamp is installed, the connection between the ceiling lamp and the ceiling should be maintained frequently to prevent the ceiling lamp from falling and causing danger.