Kitchen Faucets Manufacturers introduces how to repair the leaking phenomenon of basin faucet

1. If the hot and cold water faucet is controlled by a main water inlet valve, close the main valve. When the hot and cold water inlet pipes are separated, then close the two corresponding valves.
2. Use a flat-blade screwdriver to open the accessories;
3. Use a flat-blade screwdriver to reach into the handle fixing screw hole plug (cold and hot standard hole), and the counterclockwise (left-handed) screwdriver about 3 turns;
4. Fully grasp the faucet handle with your left hand, push it upwards, and at the same time use the screwdriver's rear handle (must be non-metallic material, otherwise it will damage the outer surface of the faucet and tap it upwards so that the accessories are separated;
5. Counterclockwise (left-handed) fittings, the end cap is separated from the main body;
6. Use the opening of the adjustable wrench on the accessory position, adjust the opening size of the adjustable wrench, rotate it counterclockwise, remove the ceramic valve core for inspection, if it is intact, turn it clockwise (right-handed), tighten the tension; if it is damaged, replace it with a new one Spool.
7. Reinstall the accessories as they are
8. There is no water leaking from the water tap: this happens when the axial gasket in the tap is worn. According to the size of the faucet, choose the corresponding pliers to unscrew the faucet gland, and use the clamp to remove the worn shaft gasket, and then replace it with a new auxiliary gasket to solve the problem. Water leakage occurs at the joint of the faucet nozzle: check whether the nut of the lower nozzle is loose. Tighten the nut or replace it with a new U-shaped gasket.