Home / News / Maintenance Strategy Of Stainless Steel Kitchen Faucet Water Purifier

Maintenance Strategy Of Stainless Steel Kitchen Faucet Water Purifier

The majority of domestic products use microporous ceramic filter and nano-KDF filter, dechlorination ball, alkaline ball-based water purification technology, the water flow is greater than the Stainless Steel Kitchen Faucet  water filter using hollow fiber technology, ceramic filter It can be cleaned and used repeatedly. After a certain service life, the filter element needs to be replaced regularly.

1. Activated carbon is the main water purification material of the faucet water purifier. The nano-active filter element has better adsorption capacity, and has better filtering effect on chlorine, heavy metals and pesticides in water before adsorption saturation.

2, hollow fiber technology is based on hollow fiber membrane water purification technology, can filter out most of the pollutants in the water, the filter should be replaced regularly.

3, ceramics and nano-KDF technology Most of the domestic products use microporous ceramic filter and nano-KDF filter material, dechlorination ball, alkaline ball-based water purification technology, the water flow is greater than the net using hollow fiber technology The water filter and ceramic filter element can be used repeatedly for cleaning. After a certain service life, the filter element needs to be replaced regularly.

First, maintenance methods

1. Tighten the faucet first, and use a wrench to turn the faucet counterclockwise to remove it.

2. Thread the hole outward and wind it 5-6 times with the wind-printing tape on the threaded part.

3, see if the faucet has been adjusted with water  wrench to enter the clock direction, after the final installation, open the main switch to try to see if there will be water leakage.

Second, the cause of water leakage

1. Causes of water leakage at the outlet: due to wear of the shaft gasket in the faucet. Use pliers to loosen and remove the gland, remove the shaft gasket with a clip, and replace it with a new one.

2. Causes of water leakage in the lower part of the faucet: This is caused by the wear of the triangular seal inside the gland. You can loosen the screw to remove the hoe, then loosen the gland, then remove the gland inside the triangle seal shop and replace it with a new one.

3. Leakage at the joint joint: Generally, the cap nut is loosened, and the cap nut can be retightened or replaced with a new U-ring.

4. The amount of water is reduced: It may be that the water leakage condition occurs, because the water stop disk of the single gun faucet is stuck with the sand stone. This phenomenon is still to find a professional repairer to disassemble the faucet to clean, but if the rubber pad is damaged, it must be replaced.