Home / News / The Installation Process For Kitchen Faucets

The Installation Process For Kitchen Faucets

First, close the main sluice gate of the Kitchen Faucets , and use tools to turn the old faucet in the opposite direction to remove it; secondly, do not install the new faucet immediately, because the faucet will accumulate sediment over time, so first remove the sediment in the water pipe Then, use the raw material tape around the threaded part of the faucet several times to avoid water leakage from the faucet; finally, screw the faucet to the water pipe in the positive direction. Specific steps are as follows:

1. Connect the hose to the faucet, choose to insert the hose into the faucet mouth, tighten it by hand, try to pull it again to see if it is firm, and then fix other accessories to the faucet.

2. To fix the faucet, pass the installed hose through the basin, fix it with accessories, and then try to see if the faucet and the basin are connected tightly without loosening, and then tighten with screws.

3. Connect the water inlet, put the basin in the designated position, and then connect the other end of the hose to the water inlet pipe interface. But when taking over, it is necessary to divide hot and cold water, remember that the left side is hot water and the right side is cold water. This completes the installation of the faucet.