Stainless Steel Sink Manufacturers Teaches You What To Pay Attention To When Installing The Sink

The usual washing and dishwashing cannot be separated from the sink. It takes a long time to find that the sink starts to seep or loose, and you will mistakenly think that the service life of the sink is at the end. This is not the case. The life of the sink has been around for a long time. The reason why it is shaking or seeping is because some details are not noticed during the installation, which leads to this phenomenon. Today, Stainless Steel Sink Manufacturers teach you how to solve this problem from the root cause.

1, the sink position should be reserved

Reserve a good sink and provide the approximate size of the sink when you purchase the sink. It is best to have a floor plan provided to avoid rework and lead to rework. When the sink is installed, the position reserved for the countertop should match the volume of the sink. The sink should be installed firmly and the tank should not be shaken from side to side. The installation of the sink is not a big project in the whole decoration, but pay attention to the sealing of the joints during the installation process.

2, first install the faucet and inlet pipe

Install the faucet and inlet pipe before installing the sink. In addition, one end of the inlet pipe on the faucet is connected to the water inlet switch.

3, the sink is placed on the countertop

After placing the countertop, it is necessary to install a matching hanging piece between the trough and the countertop. The sink should be installed firmly and the tank should not be shaken from side to side. The installation of the sink is not a big project in the whole decoration, but pay attention to the sealing of the joints during the installation process.

4, overflow hole, filter basket seal

The degree of sealing of the overflow hole and the filtered blue is affecting the use of the sink in the future. Therefore, the degree of sealing of the overflow hole and the filtered blue is very important. After the installation is completed, it is necessary to check the sealing of the overflow hole and the filter basket.

5, install supporting hanging pieces

Install the hanging piece of the sink. After the sink is bought, the worker will cut the countertop according to the size of the sink. After placing the countertop, you need to install the matching hanging piece between the trough and the countertop. When installing, avoid small gaps and cause the tank to shake to better prevent leakage in the future.

6, drainage test, edge banding

After the installation is completed, a drainage test is carried out, the water tank is filled with water, and the drainage of the sewage water and the overflow hole is tested. If there is any water seepage when draining, rework immediately. After the drainage test, ensure that there is no problem, the sink can be sealed. When sealing with silicone, ensure that the gap between the sink and the table is even and there is no water seepage.