China Stainless Steel Sink Installation And Corner Treatment

The drain of the China Stainless Steel Sink must be left in the sink cabinet and an angle valve should be installed before installing the sink. To avoid damage to the outer surface of the faucet when installing the faucet, place the faucet sleeve or faucet plastic bag on the faucet to install the faucet.

When connecting the hot water pipe and the cold water pipe, face the faucet, the left end is connected to the hot water pipe, and the right end is connected to the cold water pipe. When installing bellows or braided tubes, be sure to pay attention to the tightening force. If it is too large, it is easy to damage the thread. If it is too small, it may leak due to the seal.

After the installation is complete, commission the water supply to the stainless steel sink. Reminder: Regarding the opening size of the stainless steel sink, the opening size of the stainless steel sink is generally 2cm-2.5cm of the outer diameter of the sink, and the angle R of the opening of the stainless steel sink is very important. Finally, if you have two slots installed, it is recommended that you use two slots alternately to ensure that the slots are not blocked or leaking.

Regarding the corner treatment of the sink, the corners of the stainless steel sink on the market are processed in various ways, with flat square corners, rounded corners, thin edges, beveled edges and floating edges. Among them, the square corner can be used as an above counter basin or as an under counter basin, but since it is a square corner, on the one hand, the viewing angle is not very good, and its carrying weight is not very strong, and it is in the process of transportation. The folds are easy to fold and are now used less, and the flanging enhances the flatness of the sink.

On the other hand, the ribs make the sink load stronger and have a good water retention effect. Let the water flow to the countertop. Many sink manufacturers now like this technology, but they must be double-layered to produce results. You can see it on the market, many of which are unilateral. At the same time, we can see that the sides of the high-grade stainless steel sink are usually flat and have no large curvature.