Stainless Steel Laundry Sink Buying Skills

Many modern homes have a sink. The kitchen needs a sink to clean the dishes, and the bathroom needs a sink to wash your face. Some people also installed a laundry chute on the balcony to facilitate daily laundry. In many sinks, stainless steel is a very common sink, below Afarstainlesskb how to buy a Stainless Steel Laundry Sink?

First, stainless steel laundry tubs should be one-piece

At present, many stainless steel laundry tanks are integrally formed and are better than welding methods. When the weld cracks, cracks can be felt by hand. The size and quality of ordinary welds are one of the most important factors affecting the life of the sink. Good welding prevents rusting and desoldering. However, there is no such trouble when selecting a single piece.

Second, the best steel plate for producing sinks is 304 steel plates

Regardless of hardness and wear resistance, steel plates are suitable for use in laundry tanks. The surface of the steel is particularly smooth, free of dust and does not require excessive cleaning. Rinse with water and dry naturally.

Third, it is easy to clean and flat

The most intuitive criteria for determining quality and grade are: Gloss after cleaning and no smear. Antifouling is the most important when choosing a sink. In order to make the sink clean, many people are accustomed to using wire brushes. The sink is temporarily clean, but in this case the sink actually gets dirty faster. The ball will pull the sink and the gap will contain more and more dirt.

Fourth, the thickness of the sink should be moderate, too thin and too thick to be good

The thickness of the general tank is 0.8mm-1.0mm, and the thickness is 1mm is relatively good, too thin will affect the service life and strength of the stainless steel laundry tub. A good stainless steel laundry bucket uses a thicker plate. Since the cleaning tank is edge-treated, it is difficult to see the thickness at one time. The easiest way is to gently press the surface of the stainless steel laundry tank. If you press it, it means the material is very thin, of course. If you can borrow vernier calipers and micrometers, it is very professional.