What Should I Do With The Glass Glue On The Side Of The Stainless Steel Kitchen Sink?


Stainless Steel Kitchen Sink  have always been used mos […]

Stainless Steel Kitchen Sink  have always been used most frequently in the kitchen, while kitchen sinks are generally decorated with stainless steel sinks. The gap between the sink and the tiles is sealed with glass glue, often using sinks for washing dishes, washing dishes, etc. If it is not dried in time, the damp will cause the glass glue to become black and mildew, and it will be disgusting to look at. It is also very laborious to organize. But fortunately, there are good ways to edit small pieces, and you can use your small items to sort them out in minutes. Learn together!

1.84 disinfection / toilet spirit

If it is mildly mildew, we can use 84 disinfectant or toilet spirit. It can be brushed with a toothbrush, and it can be cleaned up with a few brushings. It is really effective. Or, you can soak the cloth in the disinfectant, take it out and put it on the moldy place. Just one night, wipe it with a rag the next day. The strip can be cleaned as before.

2. Bleaching agent

Of course, bleach is also a good way. First, prepare a few sheets of toilet paper, cut the paper into strips of the width of the sink, circle the sink, then pour the bleach, and wipe it off with a rag for about an hour. It can be as clean as a new one. In fact, when the glue is moldy, it is wet. If we put a layer of waterproof sticker on the side of the sink, it is beautiful and can save these troubles.

3. Utility knife removal

For people with cleanliness, the mold on the side of the sink is really a very disgusting thing, and the mold is not only dirty, but also affects the health of the kitchen. Of course, if you are still too troublesome, the Xiaobian also has a great trick - use the utility knife to remove the blackened glass glue, all removed. There is also the glass glue of the water-sinking place of the sink. If it is moldy, it can not be directly removed. You can buy a special mold-proof glue, squeeze the glue slowly to smooth the gap, and seal the edge of the mold-proof glue. The ability is still very strong.