Stainless Steel Faucets Manufacturer Introduces Faucet Installation Skills

Stainless Steel Faucets manufacturer introduces faucet installation skills:

1. After buying the faucet, first check whether the fastening accessories include the following basic parts: 1 full copper gasket, 2 rubber washers, and 1 fastening nut;

2. Cover the two inlet hoses with rubber washers and all-copper washers in turn. The basin is a ceramic basin. The rubber washers are added to ease the contact pressure between the surface of the faucet and the ceramic basin and avoid wear of the porcelain basin;

3. Insert a water inlet pipe into the water inlet end of the basin faucet and tighten it;

4. Insert the second water inlet hose into the water inlet port of the basin faucet, and tighten the copper joints evenly;

5. Use rubber pads to insert from the lower end of the two water inlet hoses;

6. Put on the fastening nut to lock the basin faucet;

7. Connect the other ends of the two water inlet hoses with the water outlet angle valve respectively. When connecting, pay attention to distinguishing the cold and hot water on the other side. If the connection is wrong, the faucet cannot be tapped normally. Tighten the interface between the two hoses and the angle valve after connection. Do not tighten the interface too hard, which may cause the interface to deform.